Flywheel, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
- Replace bolts that were tightened with an additional turn after removing them.
The threads in the crankshaft must be cleaned before continuing assembly.
-- Clean the crankshaft flange, until all of the adhesive residue is completely removed.
- Do not damage the shaft seal when cleaning the flange.
- Remove any loosened adhesive residue with a vacuum cleaner, and do not use compressed air under any circumstances.
-- Remove adhesive residue from one of the old drive plate bolts -2- with the wire brush, and remove oil residue with brake cleaner.
-- Keep inserting and removing the cleaned bolt in the thread on the crankshaft -1- until no more adhesive residue is extracted.
- Do not insert the bolt too far, so that it does not damage the components behind.
-- When adhesive residue is no longer extracted, repeat the procedure on the other crankshaft threads.
- Lastly, remove any loosened adhesive residue with a vacuum cleaner, and do not use compressed air under any circumstances.
-- Clean the crankshaft flange with a cloth.
- The threads in the crankshaft must not have any oil or grease on them.
-- Place the Flywheel Retainer: 3067 into the hole on the cylinder block -A-.