Engine Temperature Control Actuator -N493-, REMOVING AND INSTALLING: Installing
Install in the reverse order of removal while noting the following:
- Replace the seals and O-ring -4- after removal.
-- Coat the new O-rings -4- with coolant.
-- Make sure that both centering pins are installed in the cylinder block if necessary insert.
-- Install the connection piece -2- into the engine oil cooler -1-.
-- Push the Engine Temperature Control Actuator -N493- -3- onto the connecting piece and centering pins in the cylinder block.
-- Install the coolant pump. Refer to COOLANT PUMP, REMOVING AND INSTALLING .
-- Install the Throttle Valve Control Module -GX3-. Refer to Throttle Valve Control Module -GX3-, REMOVING AND INSTALLING .
There are additional procedures depending on the model. Refer to Engine Temperature Control Actuator -N493-, REMOVING AND INSTALLING .
-- Perform the adaptation after replacing using the Vehicle Diagnostic Tester.