Wheel Bearing Unit, Removing And Installing, Fwd Vehicles, Version 1: Installing
Install in the reverse order of removal while noting the following:
- Replace the dust cap and bolt after removal.
-- Carefully slide the wheel bearing unit onto the axle stub.
- Make sure that the wheel bearing unit does not tilt!
CAUTION:
There is a risk of damaging the bolt if handled incorrectly.
- Never use an impact wrench to loosen or tighten.
- Position the bolt by hand only and screw in the first threads.
-- Drive in the new dust cap all the way using the Camshaft Installer Kit - Sleeve : 3241/4 -item 1-.
-- Install the brake rotor. Refer to BRAKE ROTOR, REMOVING AND INSTALLING .