Left Parking Brake Motor -V282- /Right Parking Brake Motor -V283-, REMOVING AND INSTALLING: Installing
Install in reverse order of removal and note the following:
- Replace the seal after removal.
- The ring groove -arrow- for the gasket and the parking brake motor contact surface must not be damaged.
-- Clean the parking brake motor ring groove and contact surface.
-- Coat the new seal -1- thin with Lithium Grease and install.
-- Completely grease the Torx insert on the parking brake motor drive axle.
-- Slightly turn back the input shaft using the Socket: T10621 -A- until the parking brake motor can be positioned correctly.
- Do not remove the gasket -1- when assembling the parking brake motor.
-- Rotate the parking brake motor until the bolt hole and threads are aligned.
- The parking brake motor must be flush with the brake caliper. Under no circumstances may it be pulled against the brake caliper with bolts.
-- Tighten the bolts -arrows-.
-- Connect the connector -1-.
-- Connect the Vehicle Diagnostic Tester to the vehicle diagnostic connection when the ignition is switched off.
-- Switch the ignition on.
-- Select Diagnostic and start.
-- Select the Test plan tab.
-- Select Individual tests and select the following tree structures one after the other:
- Diagnostic-Capable System
- 0003 - ABS Control Module -J104-, integrated parking brake
- 0003 - Electronic parking brake functions
- 0003 - Basic setting
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
Faulty brakes increase the risk of an accident.
- Make sure the brakes are working correctly before driving the vehicle for the first time.