LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> Q3 Premium Plus >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Mechanical Components (Brake System) >> 46 Mechanical Components >> Rear Brakes >> Brake Shield, Removing And Installing >> Installing

Brake Shield, Removing And Installing: Installing

Install in reverse order of removal and note the following:

-- Clean the contact surfaces on the brake shield and wheel hub.

-- Install and tighten the brake shield bolts.

-- If removed, install the brake carrier. Refer to BRAKE CARRIER, REMOVING AND INSTALLING .

-- If removed, install the wheel bearing unit. Refer to WHEEL BEARING UNIT, REMOVING AND INSTALLING .

-- Install the brake rotor. Refer to BRAKE ROTOR, REMOVING AND INSTALLING .

CAUTION:

Faulty brakes increase the risk of an accident.

- Make sure the brakes are working correctly before driving the vehicle for the first time.

-- With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.

scientia non olet · About LEMON Manuals