Brake Master Cylinder, Removing And Installing, Vacuum Brake Booster: Removing

-- Remove the brake fluid reservoir. Refer to BRAKE FLUID RESERVOIR, REMOVING AND INSTALLING .

-- Remove the battery tray. Refer to BATTERY TRAY, REMOVING AND INSTALLING .

-- Disconnect the connectors:

Fig 1: Component Location - Brake Lamp Switch -F- /Brake Pedal Switch -F63- and Vacuum Sensor -G608-.

Courtesy of AUDI OF AMERICA, LLC

1. From the Brake Lamp Switch -F-
2. From the Vacuum Sensor -G608-, if equipped

-- Remove the brake lines -1- on brake master cylinder.

Courtesy of AUDI OF AMERICA, LLC

-- Immediately close open connection points with a clean plug.

-- Remove the nuts -2-.

• Do not let anything fall in the brake booster when removing the brake master cylinder.
• The actuator pin for the brake lamp switch must not get lost.

-- Disconnect and remove the brake master cylinder from the brake booster.