Sunroof Motor -V1-, REMOVING AND INSTALLING, Q3 SPORTBACK: Removing
- Open the sunroof shade completely.
-- Switch off the ignition.
-- Remove the front interior lamp/reading lamp. Refer to FRONT INTERIOR LAMP/READING LAMP, REMOVING AND INSTALLING .
-- Remove the left and right sun visors. Refer to SUN VISOR, REMOVING AND INSTALLING .
-- Remove the sun visor center support. Refer to SUN VISOR CENTER SUPPORT, REMOVING AND INSTALLING .
Versions with Driver Assistance Systems Front Camera:
-- Unclip the cover -1- using the clip release lever -arrows A, B, C- by carefully inserting the clip release lever between the windshield and the cover.
-- Repeat the procedure on the opposite side.
-- Disengage the front of the cover -1- and remove it toward the rear.
Continuation:
-- Remove the left and right A-pillar upper trim panel. Refer to A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Remove the left and right front roof grab handle. Refer to ROOF GRAB HANDLE, REMOVING AND INSTALLING .
-- To avoid dirtying the headliner, clean the Removal Wedge: T40233 .
-- Push the Removal Wedge: T40233 between the sunroof frame -1- and the headliner.
-- Using the Removal Wedge: T40233 , loosen the front of the headliner from the sunroof frame -arrows-.
There is a risk of damage due to improper handling.
- Do not kink the headliner.
-- Lower the front headliner slightly.
-- Remove the bolts -arrows- and the sunroof motor -2-.
-- Release and disconnect the connector -1-.