Driver Backrest Adjustment Motor -V45- /Front Passenger Backrest Adjustment Motor -V46-, REMOVING AND INSTALLING, Q3: Installing
-- Check the left and right position of the backrest frame and hinge.
- The backrest frame must be in the position marked on the left and right side before removal -arrows-.
-- If necessary, correct the position accordingly.
-- First slide the adjustment shaft through the backrest hinge (tunnel side) up to the mount in the backrest adjustment motor.
-- Check whether the profile of the inserted adjustment shaft and mount in the backrest adjustment motor align.
-- If the position varies, connect an external 12-volt power source to the backrest adjustment motor and turn the mount until the profiles of the adjustment shaft and mount are congruent.
-- Slide the adjuster shaft through the mount in the backrest adjustment motor -2- and slide the hinge side sill side until it stops.
-- Tighten the bolt -arrow- for the backrest adjustment motor.
-- Push the new lock washer -1- onto the adjustment shaft -2- so that there is still at least 1.0 mm of play.
Further installation is performed in reverse order of the removal.