Sill Panel Trim, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
- The vehicle and the trim must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution and let it dry.
-- Remove the protective film from the adhesive tape -1, 2, and 3-.
-- Position the sill panel trim -4- over the pins on the side sill -arrows-.
-- Press the sill panel trim by hand on the side sill.
- Resting time approximately 30 minutes at room temperature