Fuse Panel B -SB- IN E-BOX, REMOVING AND INSTALLING: Removing
-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Press the release buttons in direction of -arrow- and remove the cover -1- for the engine compartment E-box.
-- Using a screwdriver, release the tab -2- and remove the front cover -1- upward in direction of -arrow-.
-- Mark the wires at the threaded connections for reinstallation.
-- Remove the nuts -1, 2, 4, 5 and 6- and bolt -3- and free up the wires -arrow-.
-- Cut the lower cable ties on the wiring harness.
-- Release the retainers -1, 2 and 4- in direction of -arrow- and remove the fuse panel B -3-.