Drivetrain Control Module -J775-, REMOVING AND INSTALLING: Removing

-- Remove the center console. Refer to Center Console, Removing And Installing .

-- Remove the Access/Start System Antenna 1 in Vehicle Interior -R138-. Refer to Overview - Access/Start Authorization System .

-- Equipped on some models: Remove the rear air duct. Refer to Overview - Air Routing And Air Distribution In Vehicle Interior .

-- Cut through the carpet connecting piece -1- at the position shown in the illustration -arrow A- using scissors.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -B arrows-.

-- Unclip the control module cover -2- from the threaded pins.

-- Unclip the wiring harness from the cover using the :80-200  and free it up.

-- Pull the control module cover out from under the carpet and remove it.

-- Remove the nuts -arrows-, and remove the Electronic Damping Control Module -J250- -1-.

Fig 1: Electronic Damping Control Module -J250- - Tightening Specification

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.