Molded Foam Part, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in the reverse order of removal while noting the following:
-- Engage the pedestrian protection crash sensor -1- into the molded foam part -3-.
CAUTION:
Risk of damaging the pressure hose by deforming it.
- Never kink or stretch the pressure hose.
-- Insert the pressure hose -2- into the recess in the molded foam part.
- The pressure hose must be inserted without any tension.
-- If equipped, insert the reinforcement -1- in the molded foam part -2-.
CAUTION:
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
-- Attach the connector -1- to the crash sensor until it clicks into place in direction of -arrow-.
-- Push in the connector lock -2- to secure the connector.