SUBFRAME Front Hydraulic Bonded Rubber Bushing, Replacing: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Torque Wrench 1332 40-200Nm :VAG1332
- Hydraulic Press :VAS6178
- Pneumatic/Hydraulic Foot Pump :VAS6179
- Bearing Installer - Wheel Hub/Bearing Kit :T10205A
- Assembly Tool :T40328
- Assembly Tool :T40373
NOTE:
If a bonded rubber bushing is faulty, then the bonded rubber bushing on the opposite side must also be replaced. Refer to the Parts Information for the allocation.
Check the other bearing before switching out a defected bonded rubber bushing.
If cracks, oil leaks or other damage is visible, this bonded rubber bushing must also be replaced.