Tie Rod, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
NOTE:
Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
-- Remove the boot. Refer to BOOT, REMOVING AND INSTALLING .
-- Position the front wheels as follows:
- For the left tie rod, turn the steering to the left until it stops
- For the right tie rod, turn the steering to the right until it stops
-- Remove the spring clip with the : VAG1923 -2- by counterholding at the steering gear steering rack with an open end wrench -1-.
CAUTION:
There is a risk of the steering gear being destroyed by moisture and dirt.
- There must be a visible film of grease present on the steering rack near the splines. If the film of grease is missing, replace the steering gear.