Steering Gear, Removing And Installing: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Torque Wrench 1331 5-50Nm: VAG1331
- Torque Wrench 1332 40-200Nm: VAG1332
- Engine and Gearbox Jack: VAS6931
- Ball Joint Splitter : VAS251805
- Locating Pin: T40334
- Support Brace: T40335
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Nut - Steering Gear with Tie Rods to Wheel Bearing Housing
- Bolt - Steering Intermediate Shaft to Steering Gear with Tie Rods
- Bolts - Subframe Crossbrace/Steering Gear to Subframe