Steering Gear, Removing And Installing: Installing

Install in reverse order of removal and note the following:

-- Install the subframe crossbrace. Refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING .

-- Install the steering intermediate shaft. Refer to STEERING INTERMEDIATE SHAFT, REMOVING AND INSTALLING .

After installing a new steering gear with Power Steering Control Module -J500-, activate the control module.

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic  operating mode.

-- Select the Test plan  tab.

-- Select the Select individual test  button and select the following tree structure consecutively:

• Chassis
• Steering
• 0001 - OBD-capable system
• 0044 - Power Steering Control Module J500
• 0044 - Power Steering Control Module functions
• 0044 - Replace control module

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.

• Overview table for when an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .