Active Steering Safety Lock (Locking Solenoid), Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
-- Place the adjusting element according to the mark applied during removal and tighten (use the socket included in the repair kit). Refer to Figure.
-- Connect the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Chassis
- Steering
- 0001 - OBD-capable system
- 001B - Active Steering Control Module - J792
- 001B - Active Steering Control Module, functions
- 001B - Basic setting
- 001B - Basic setting complete
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.