Diagnostic Procedures, Performing
WARNING: This page is about a different variant/trim than selected.
Procedure:
-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .
-- Select Diagnostic mode and start the diagnosis.
-- Perform the vehicle identification.
-- Remove the hooks with Guided Fault Finding procedures .
-- Switch to the Special Functions tab and select the following program:
- Entire pre-delivery inspection
-- Start the program using Perform test... .
-- Follow and complete the program sequence.
-- Switch to the Control modules tab and press the Guided Fault Finding button and perform the Guided Fault Finding through to the test plan.
-- Complete the test programs on the fault locations from the DTC memory to be read out.