Connected Gateway, Replacing Emergency Battery: Removing
WARNING: This page is about a different variant/trim than selected.
-- Switch off the ignition and all electrical equipment and remove the ignition key.
-- Remove the bench seat. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .
The Data Bus on Board Diagnostic Interface -J533- must not be removed.
-- Release the retainers and remove the cover upward from the Data Bus on Board Diagnostic Interface -J533- -1- in the direction of -arrow-.
-- Pivot the Telematics Emergency Battery -A16- -1- out of the Data Bus on Board Diagnostic Interface -J533-.
-- Release and disconnect the connector.