LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 50 (Turbocharger, Supercharger [DMTA,DPAA,DPUA,DPVA,DMTC]) >> 21 Turbocharger, Supercharger >> Charge Air System >> Charge Air Cooler, Removing And Installing >> Removing

Charge Air Cooler, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the bumper cover end plate. Refer to OVERVIEW - BUMPER COVER .

Audi A4/A5/Q5:

-- Remove the right and left air intake grille as well as the bumper cover end plate. Refer to OVERVIEW - BUMPER COVER .

Audi Q5:

GWWA21-11081Courtesy of AUDI OF AMERICA, LLC

-- Carefully free up the air ducts -1 and 3- on the bottom of the charge air cooler and push slightly to the side.

Audi A4/A5/A6/A7:

-- Remove the lock carrier cover. Refer to Front Bumper .

-- Release the catches in direction of -arrow- and remove the air ducts -1 and 3-.

Continuation for All Vehicles:

GWWA21-11082Courtesy of AUDI OF AMERICA, LLC

-- Loosen the left and right hose clamp -1- and remove the air duct pipe from the charge air cooler.

-- Seal off any open lines and connections with plugs that are thoroughly cleaned from the :VAS6122  .

CAUTION:

Risk of damaging the retainers due to improper handling.

- Carefully release the retainers.

-- Release the retainers in direction of -arrows- on the left and right sides and disengage the charge air cooler from the radiator.

-- Remove the charge air cooler downward.