Wheel Bearing Unit, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
CAUTION:
There is a risk of damaging or contaminating the wheel bearing.
- Handling the wheel bearing. Refer to OVERVIEW - WHEEL BEARING => The wheel bearing -1- must always face up in order to remove the wheel bearing unit. .
-- Loosen the connection between the drive axle and wheel hub. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
-- Remove the brake rotor. Refer to BRAKE ROTOR, REMOVING AND INSTALLING .
-- Remove the bolts -arrows-.
-- Remove the wheel hub -2- with the wheel bearing unit from the drive axle -3- and remove it from the wheel bearing housing -1-.