Upper Control Arm, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Before starting the procedure, determine the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
-- Remove the front wheel. Refer to WHEELS AND TIRES .
-- Turn the wheel hub, until a wheel bolt hole is at the top.
-- Install the : T10149 with a wheel bolt -2- on the wheel hub.
NOTE:
Ignore item -1-.
-- Support the wheel bearing housing over the : T10149 using the : VAS6931 .
WARNING:
Risk of accident!
- Do not lift or lower the vehicle when the : VAS6931 is under the vehicle.
- Do not leave the : VAS6931 under the vehicle any longer than necessary.
-- Loosen the threaded connection -2-.
CAUTION:
There is a risk of damaging the wheel bearing housing.
- The slits in the wheel bearing housing must not be widened using a chisel or similar tool!
-- Remove the corresponding joint pins in the upper control arm -3- from the wheel bearing housing.
-- Remove the bolt -1 or 4- and remove the corresponding upper control arm.