Upper Control Arm, Removing And Installing: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
- Torque Wrench 1331 5-50Nm: VAG1331
- Torque Wrench 1331 Insert - Ring Wrench - 16mm: VAG1331/12
- Torque Wrench 1332 40-200Nm: VAG1332
- Engine and Gearbox Jack: VAS6931
- Engine/Gearbox Jack Adapter - Wheel Hub Support: T10149
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolt - for Upper Control Arm Bushing
- Bolt/Nut - Upper Control Arm Bushing to Wheel Bearing Housing