Overview - Suspension Strut Coil Spring
WARNING: This page is about a different variant/trim than selected.
- Protective Cover
- Stop Buffer
- Coil Spring
- Spring Support
- Strut Mount
- Installation position. Refer to Fig 2.
- Nut
- 50 Nm
- Always replace after removing
- Cap
- Can only be installed in one position
- Cap
- Equipped on some models
- Protective Cap
- Spring Washer
- Lower Spring Plate
- Shock Absorber
- Because of different shock absorber valve systems, only install new shock absorbers from the same manufacturer on both axles, if possible.
- Removing and installing. Refer to SUSPENSION STRUT, SERVICING . For equipment versions with electronic damping: "Adapt new control position" using the Vehicle Diagnostic Tester after replacing.
Suspension Strut Coil Spring Installation Position
- The strut mount positioning pin -1- must engage in the hole -2- in the suspension strut tower -arrow-.