SUBFRAME With Steering Gear, Removing And Installing: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Torque Wrench 1331 5-50Nm: VAG1331
- Torque Wrench 1332 40-200Nm: VAG1332
- Engine and Gearbox Jack: VAS6931
- Ball Joint Splitter : VAS251805
- Tensioning Strap: T10038
- Puller - Ball Joint: T40043
- Locating Pins: T40327
- Elbow Assembly Tool: T10118
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolts - Subframe Crossbrace/Steering Gear to Subframe
- Nut - Coupling Rod to Shock Absorber Fork
- Nut - Stabilizer Bar to Coupling Rod