SUBFRAME CROSSBRACE, Removing And Installing: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Torque Wrench 1331 5-50Nm: VAG1331
- Engine and Gearbox Jack: VAS6931
- Rear Axle Support: T10552
- Puller - Ball Joint: T40043
- Strut: T40335
- Locating Pin: T40334
- Mount: T40386 , not illustrated
Tools, Preparing
-- Loosen the bolts -arrows-.
-- Adjust the dimension -a-.
- Dimension -a- = 250 mm
-- Tighten the bolts again.
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolts - Subframe Crossbrace to Subframe
- Bolts - Subframe Crossbrace/Steering Gear to Subframe
- Bolt - Clip to Subframe Crossbrace