Stabilizer Bar
WARNING: This page is about a different variant/trim than selected.
- Nut
- 30 Nm
- Always replace after removing
- Remove and tighten evenly alternating from side to side.
- Clamp
- Stabilizer Bar
- With rubber bushing
- The rubber bushing cannot be replaced separately
- Removing and installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING .
- Nut
- 40 Nm + 90°
- Always replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Subframe
- Bolt
- Always replace after removing
- Coupling Rod
- Removing and installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
- Shock Absorber Fork
- Removing and installing. Refer to SHOCK ABSORBER FORK, REMOVING AND INSTALLING .
- Nut
- 40 Nm + 90°
- Always replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Bolt
- Always replace after removing