Control Arm, Removing And Installing: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Spreader Tool: 3424
- Torque Wrench 1332 40-200Nm: VAG1332
- Engine and Gearbox Jack: VAS6931
- Ball Joint Splitter : VAS251805
- Engine/Gearbox Jack Adapter - Wheel Hub Support: T10149
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolt/Nut - Control Arm to Subframe
- Bolt - Control Arm to Shock Absorber Fork
- Nut - Ball Joint to Control Arm