Oil Spray Jets, Removing And Installing: Notes

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Removing cylinder "1" through "3" :

-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Risk of damaging the engine by the timing mechanism skipping.

- Only let the engine turn in the direction of engine rotation.

-- Turn the crankshaft at the vibration damper with the : T40263 , :T40314 and the 24 mm socket -arrow- until the corresponding bolt is accessible.

Removing Cylinder "4" :

-- Remove the crankshaft. Refer to CRANKSHAFT, REMOVING AND INSTALLING .

Continued for All Cylinders:

Fig 1: Exploded View Of Oil Spray Jet And Pressure Relief Valve

Courtesy of AUDI OF AMERICA, LLC

-- Remove the pressure relief valve -1- using the :T10545 .

-- Remove the oil spray jet -2-.

Installing

Install in the reverse order of removal while noting the following:

CAUTION:

There is a risk of damaging the oil spray jets through distortions.

- Never bend the oil spray jets.

-- Install the crankshaft. Refer to CRANKSHAFT, REMOVING AND INSTALLING .

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .