Vibration Damper, Removing And Installing, Version 2: Notes
WARNING: This page is about a different variant/trim than selected.
Vibration damper, version 2. Refer to Figure.
Special tools and workshop equipment required
- Wrench - 21mm :T40263
- Adapter :T40314
- Counterhold :T40379
- Vibration Damper Assembly Tool :T10531
- Vibration Damper Assembly :T10531/5-/6
- The vibration damper bolt -A- connects the vibration damper -1-, the timing chain sprocket -2- and the crankshaft -3- with each other. Before removing the bolt, the chain sprocket must be secured to the crankshaft as described in the following.
Tool Preparation
-- Remove the bolts -arrows- and remove the adapter -1- from the :T10531/1 .