Rear Heat Shield For Longitudinal Member, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the plenum chamber bulkhead. Refer to PLENUM CHAMBER BULKHEAD, REMOVING AND INSTALLING .
-- Remove the rear noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING, REAR .
Right:
-- Remove the front muffler/front exhaust pipe. Refer to OVERVIEW - MUFFLER [CWGD, DECA] or OVERVIEW - MUFFLER [CYMC] and OVERVIEW - EMISSIONS CONTROL SYSTEM [CWGD, DECA] or OVERVIEW - EMISSIONS CONTROL SYSTEM [CYMC] .
-- Remove the lock washers -arrows-.
-- Remove the heat shield -1-.
Left:
-- Remove the lock washers -arrows-.
-- Remove the heat shield -1-.