Rear Lid Motor 1 And 2 -V444- And -V445-, Adapting
WARNING: This page is about a different variant/trim than selected.
-- Connect the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Body
- Body Assembly
- 01 - OBD-capable systems
- 6D - Rear Lid Electronics, J605
- 6D - Rear Lid Control Module, Functions
- 6D - Basic Setting, Rear Lid Control Module
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.