Cigarette Lighter -U1-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove antenna 1 in the vehicle interior for the access/start authorization and set to the side with the wire still connected. Refer to Access/Start System Antenna 1 in Vehicle Interior -R138-, REMOVING AND INSTALLING .

-- Disconnect the connector -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

-- Remove the lighter -2-

-- The release tabs -2- on the : T40148 must engage in the openings on the cigarette lighter -3- in direction of -arrow-. To do so, the threaded rod -1- must be slid all the way down.

Fig 1: 12 V Socket 5 -U26-

Courtesy of AUDI OF AMERICA, LLC

-- Slide the Cigarette Lighter Release Tool: T40148 all the way into the cigarette lighter -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Turn the thumbwheel -2- at the : T40148 clockwise all the way to the end stop.

The plunger -2- is pulled up and the release tabs -1- are spreading in the : T40148 -arrows-.

Fig 2: Identifying Release Tool T40148 In Use
Courtesy of AUDI OF AMERICA, LLC

-- Remove the cigarette lighter from the illumination ring with the Socket Illumination Bulb -L42- using the : T40148 .

-- Guide the wire out through the mount.