High-Mounted Brake Lamp Bulb, Removing And Installing, SPORTBACK: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
- The entire high-mounted brake lamp must be replaced if an LED is faulty.
- Replace the seals.
- The vehicle and the high-mounted brake lamp must be room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Completely remove the adhesive residue.
-- Clean the adhesive surface using the Cleaning Solution: D 009 401 04 .
-- Remove the protective film from the seal and press on the high-mounted brake lamp -1-.
- For the following step the help of a second technician is necessary.
-- Insert the high-mounted brake lamp with a second technician.
-- Remove the protective film -3- from the seal and insert in the high-mounted brake lamp bulb in the outer clip nuts.
-- Push the rubber lip -2- using the : T10383/1 under the rear window.