Vacuum, Creating With Hand Vacuum Pump
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Hand Vacuum Pump: VAS6213
Procedure
In certain situations, the vacuum can be created using a Hand Vacuum Pump: VAS6213 instead of using the engine or a vacuum pump.
-- To do so, connect the Hand Vacuum Pump: VAS6213 to the vacuum hose from the connection -B- to the Brake Servo Tester: VAS6721 .
-- Open the shut-off valve -B-.
-- Create the vacuum using the Hand Vacuum Pump: VAS6213 until a vacuum between 600 and 950 mbar (9 and 13 psi) is displayed on the Brake Servo Tester: VAS6721 .
-- Then perform the relevant tests.