Overview - Vacuum Pump, 2.0L TFSI Engine

WARNING: This page is about a different variant/trim than selected.

Fig 1: Overview - Vacuum Pump, Vehicles With 2.0L TFSI Engine

Courtesy of AUDI OF AMERICA, LLC

Vacuum Pump
- Removing and Installing. Refer to VACUUM PUMP, REMOVING AND INSTALLING, 2.0L TFSI ENGINE .
Seal
- Replace after removing.
Vacuum Hose
Bolt
- 8 Nm +180°
- Replace after removing.
Vacuum Line
- From EVAP Canister Purge Regulator Valve 1 -N80- to EVAP canister
Bolt
- 9 Nm
Bolt
- 9 Nm
Bolt
- Tightening specification. Refer to OVERVIEW - HIGH PRESSURE PUMP [CYMC] or OVERVIEW - HIGH PRESSURE PUMP [CWGD] .
High Pressure Pump
- Removing and Installing. Refer to HIGH PRESSURE PUMP, REMOVING AND INSTALLING [CYMC] or HIGH PRESSURE PUMP, REMOVING AND INSTALLING [CWGD] .
O-Ring
- Replace after removing.