Brake Fluid Reservoir, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

-- Insert the brake fluid reservoir into the plugs in the brake master cylinder.

Further installation is performed in reverse order of removal, while noting the following:

-- Fill the brake fluid reservoir up to the "MIN" mark.

Fig 1: Brake Fluid Reservoir

Courtesy of AUDI OF AMERICA, LLC

-- Remove all cloths from the vehicle that were previously placed down.

-- Bleed the brake system. Refer to HYDRAULIC SYSTEM, BLEEDING .

-- Install the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

CAUTION:

Faulty brakes increase the risk of an accident.

- Make sure the brakes are working correctly before driving the vehicle for the first time.

-- Check brake fluid level, and fill if necessary.