Carbon-Ceramic Brake Wear Tester: VAS6813, CHECKING
WARNING: This page is about a different variant/trim than selected.
"Before" Measuring, the Carbon-Ceramic Brake Wear Tester: VAS6813 must be Checked Using the Measurement Plate Provided.
Measurement Plate:
-- Place the measuring device in both openings of the measurement plate, -arrows- so that the laser beam points under the mark with the attached reference value.
-- Switch on the measuring device.
The value displayed on the display must correspond to the reference value attached to the measurement plate.
TIP:
- If the difference to the reference value is more than ± 2.0 units the measuring device must be calibrated by a specialist company.
- For more information refer to the supplied Owner's Manual.