Starter, Removing And Installing, Vehicles With 4-Cylinder Engine: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
-- Make sure the seal -2- is seated correctly inside the starter opening before installing the starter.
- The seal must seal with the opening -1- for the starter -arrows-.
CAUTION:
There is a risk of damaging the starter through improper handling.
- Tighten the bolt only with the spacer sleeve installed between the starter and the transmission.
-- Connect the battery. Required actions. Refer to BATTERY, DISCONNECTING AND CONNECTING .