Starter, Removing And Installing, Vehicles With 2.0L TDI Engine (0K4): Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
-- Check the sealing piece -arrow- for the correct installation position.
TIP:
If the starter assembly is difficult to move, use a silicone-free lubricating spray.
CAUTION:
There is a risk of damaging the starter through improper handling.
- Tighten the bolt only with the spacer sleeve installed between the starter and the transmission.
-- Connect the battery. Required actions. Refer to Connecting .