Battery, 48 V -A6-
WARNING: This page is about a different variant/trim than selected.
- Bolt
- 12 Nm
- Quantity: 5
- Cover Plate
- Battery Tray
- There are different versions. Refer to the Parts Information.
- Removing and Installing. Refer to BATTERY TRAY, REMOVING AND INSTALLING, 0K4 AND VH2 .
- Grommet
- Bolt
- Quantity: 6
- Tightening Specifications and Sequence. Refer to Fig 2.
- Pressure Equalization Hose
- Bolt
- Quantity: 2
- Tightening Specifications and Sequence. Refer to Fig 2.
- Protective Housing
- Removing and Installing. Refer to PROTECTIVE HOUSING FOR Battery, 48 V -A6-, REMOVING AND INSTALLING, 0K4 AND VH2 .
- Front Crashpad
- Retaining Bracket
- Bolt
- 8 Nm
- Quantity: 3
- Bolt
- 8 Nm
- Quantity: 4
- Positive Cable Cap
- Positive Cable
- 18 Nm
- Ground Cable Cap
- Ground Cable
- 18 Nm
- De-energizing. Refer to 48V SYSTEM, DE-ENERGIZING .
- Nut
- 20 Nm
- Bolt
- 8 Nm
- Quantity: 2
- Connector
- Retaining Bracket
- Battery, 48 V -A6-
- Removing and Installing. Refer to Battery, 48 V -A6-, REMOVING AND INSTALLING, 0K4 AND VH2 .
- Bolt
- 8 Nm
- Quantity: 2
- Retaining Bracket
- Nut
- 20 Nm
- Rear Crashpad
Protective housing for Battery, 48 VA6 - Tightening specification and sequence
-- Tighten the bolts in the sequence shown.
| Bolts | Tightening Specification |
|---|---|
| -1- | 20 Nm |
| -2- | 20 Nm |