Overview - Adaptive Cruise Control
WARNING: This page is about a different variant/trim than selected.
- Retaining Plate
- Removing and installing. Refer to RETAINING PLATE FOR DISTANCE REGULATION CONTROL MODULES -J428- / -J850-, REMOVING AND INSTALLING .
- Bolt
- 2.5 Nm
- Quantity: 3
- Clip
- Closed version
- Cannot be removed without being damaged
- Note the installation position
- Clip
- Open version
- Cannot be removed without being damaged
- Stud Bolt
- Note the adjustment dimension. Refer to Installing - Measure the dimension -a- at all stud bolts using the :VAS6335 and correct if necessary. .
- Quantity: 3
- Clip
- Must be replaced when the stud bolt is removed
- Replacing. Refer to CLIP ON Distance Regulation Control Module -J428-, REPLACING .
- Quantity: 3
- Distance Regulation Control Module
- Right: Distance Regulation Control Module -J428-
- Left: Distance Regulation Control Module 2 -J850-
- Removing and installing. Refer to DISTANCE REGULATION CONTROL MODULES -J428- / -J850-, REMOVING AND INSTALLING .
- Calibrate the adaptive cruise control (ACC). Refer to ADAPTIVE CRUISE CONTROL (ACC), ADJUSTING
- Operating Lever for Adaptive Cruise Control
- Shared component with the steering column switch module. Cannot be replaced separately
- Removing and installing. Refer to STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING .
- Instrument Cluster
- With Instrument Cluster Control Module -J285-
- Front Bumper
- Clip
- Open version
- Cannot be removed without being damaged