Seat Angle Adjuster, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Move the front seat into its highest position.
-- Unscrew the front seat and tip to the rear with the wires attached. Refer to FRONT SEAT, REMOVING AND INSTALLING .
CAUTION:
Risk of damage to the bushing in the bearing point (adjusting spindle/seat pan threaded connection -1-).
- The bushing cannot be replaced with workshop materials.
- If the bushing is damaged, the corresponding assembly parts must be replaced.
-- Remove the bolt -1- for the seat angle adjustment motor adjusting spindle.
-- Disconnect the connector -2- from the seat angle adjustment motor.
-- Remove the bolts -4- and remove the seat angle adjuster motor -3-.