Headrest, Removing And Installing, Headrest With Height And Depth Adjuster: Removing
WARNING: This page is about a different variant/trim than selected.
-- Move the headrest all the way up.
-- Power versions: remove the backrest cover. Refer to BACKREST COVER, REMOVING AND INSTALLING, STANDARD/SPORT SEAT .
-- Disconnect the connector -1- for the headrest on the bracket -arrow- and free up the wire.
-- Grab the rear cover -1- at the lower edge and push upward out of the locking mechanism in direction of -arrows-.
-- Position the backrest toward the rear at an angle.
-- Slide the trim upward, press the release ring down -arrow- on the left headrest guide and pull out the headrest upward at the same time.