Overview - Seat Position Sensor

WARNING: This page is about a different variant/trim than selected.

NOTE:

The front passenger side is shown.

Fig 1: Seat Position Sensor

Courtesy of AUDI OF AMERICA, LLC

Wiring Harness
- Seat position sensor/passenger occupant detection sensor/seat belt switch
- Clip into the seat frame
- Black connector, connector station in the vehicle floor under the seat
- Removing and Installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING .
Front Passenger Occupant Detection Sensor -G128-
- Only the front passenger side
- Removing and Installing. Refer to Front Passenger Seat Occupant Detection Sensor -G128-, REMOVING AND INSTALLING .
- Push into the seat pan until they click into place
Passenger Occupant Detection Sensor Bracket
- Clip into the seat frame
- Removing and Installing. Refer to Front Passenger Seat Occupant Detection Sensor -G128-, REMOVING AND INSTALLING .
Connector Coupling
- For the Seat Belt Latch
Seat Rail
- Tunnel-side
Seat Position Sensor
- Driver Seat Position Sensor -G553-
- Front Passenger Seat Position Sensor -G554-
- Removing, installing and adjusting. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING
- Checking using the Vehicle Diagnostic Tester.
Bolt
- 1.6 Nm