Rollover Protection, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
WARNING:
Risk of injury due to involuntary deployment.
- Follow the safety precautions for the rollover protection. Refer to SAFETY PRECAUTIONS FOR ROLLOVER PROTECTION .
Install in reverse order of removal and note the following:
NOTE:
Make sure the connectors are installed all the way and engage audibly.
Make sure the wires do not get caught.
WARNING:
Repairing pyrotechnic components (for example the airbag and seat belt tensioner) incorrectly increases the risk of injuries due to unintentional deployments when the battery is connected.
- Make sure no one is standing near the rollover protection when reconnecting the battery. Stand at least 1 meter away.
-- Connect the battery ground cable with the ignition switched on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
WARNING:
Repairing pyrotechnic components (for example the airbag and seat belt tensioner) incorrectly increases the risk of injuries due to unintentional deployments when the ignition is switched on.
- If the ignition is not switched on after the battery is reconnected - >>indicator lamps in the instrument cluster do not light up<< - the ignition (key/button) may only be switched on when the driver seat is positioned all the way back.