Overview - Driver Side Airbag

WARNING: This page is about a different variant/trim than selected.

NOTE:

The angled airbag unit is shown.

Fig 1: Exploded View Of Driver Side Airbag

Courtesy of AUDI OF AMERICA, LLC

Wiring Harness
- For Driver Airbag Igniter -N95- and Driver Airbag Release Valve Igniter -N490-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
Steering Column Electronics Control Module -J527-
- Overview. Refer to OVERVIEW - STEERING COLUMN SWITCH MODULE .
Steering Wheel
- Overview. Refer to OVERVIEW - STEERING WHEEL .
Bolt
- Tightening specification. Refer to OVERVIEW - STEERING WHEEL .
Driver Side Airbag
- With
  - Driver Airbag Igniter -N95-
  - Driver Airbag Release Valve Igniter -N490-
  WARNING:
  Risk of injury due to involuntary deployment.
  - Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING ON PYROTECHNIC COMPONENTS .
- Use a T25 TORX^® screwdriver, approximately 100 mm long
- Removing and Installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .