LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Passenger Protection, Airbags, Seat Belts) >> 69 Passenger Protection, Airbags, Seat Belts >> Driver Side Airbag >> Airbag Connector, Replacing >> Installing

Airbag Connector, Replacing: Installing

WARNING: This page is about a different variant/trim than selected.
WARNING:

Risk of injury due to involuntary deployment.

  • Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING ON PYROTECHNIC COMPONENTS .
  • Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
  • To prevent electrostatic charge, the technician must not leave the vehicle during the procedure.

-- Connect the connector -1- to the airbag igniter in direction of -arrow A-.

Fig 1: Release Connector Lock Using A Small Screwdriver & Disconnect Harness Connector
GWWA69-10923Courtesy of AUDI OF AMERICA, LLC

-- Press in the connector lock -2- in direction of -arrow B-. While doing this, the connector is pushed into the airbag igniter all the way and locks into place.

Further installation is performed in reverse order of removal, while noting the following:

NOTE:

Make sure the connectors are pushed in all the way and that they engage audibly.

scientia non olet · About LEMON Manuals