Threshold "A" In Mm Coupe / SPORTBACK
WARNING: This page is about a different variant/trim than selected.
NOTE:
If the readout value is greater than the threshold "a" (table value): insufficient damping effect → replace shock absorber.
If the readout value is less than the threshold "a" (table value): sufficient damping effect → shock absorber does not need to be replaced.
| Chassis | Front Axle | Rear Axle | Comment |
|---|---|---|---|
| 1BA | 43 mm | 46 mm | No load tank full |
| 1BE | 48 mm | 49 mm | No load tank full |
| 1BD | 46 mm | 49 mm | No load tank full |
| 1BM | 45 mm | 47 mm | No load tank full |
| 1BL / 2MV | 54 mm | 62 mm | No load tank full |
| 2MN | 54 mm | 62 mm | No load tank full |
| 2MC / 2MS | -- | -- | No load tank full |