Plenum Chamber Side Cover, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
- The vehicle and the cover must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution: D 009 401 04 and let dry.
-- Position the cover -2- using the clip on the body -1- -arrows- and press it on.
-- Remove the protective film from the adhesive tape -3- and press the cover onto the A-pillar.